Spiral Heating caused by broken or snipped conductors (above).

Resistance, opposition to current flow in a circuit. Connection anomalies pose resistance problems in our motor circuits and if they are not identified and corrected, they can have deleterious effects. Normal things that affect circuit resistance are:

1. conductor resistance
2. length of the wire
3. size of the wire in circular mils
4. temperature of the wire (copper positive temperature coefficient)

The above are physical properties for which we have little or no control.  Unfortunately, most resistance anomalies in our motor circuits are self-imposed. This includes but not limited to:

1. Improper torque
2. Connection anomalies
3. Improper operation
4. Improper maintenance

Resistance anomalies create heat, which increases resistance, which creates more heat, which creates more resistance. The cycle continues until you either find the problem or it finds you. It can thermally degrade to the point of catastrophic failure.

Combining Ohm’s Law and Watt’s Law, we transpose equations to resolve P = I²R or Power is equal to the current flowing in the circuit squared, times the resistance its flowing through, which can be quantified in Watts.

For example: assuming 1 ohm of resistance:

5 amps = 5² x 1 ohm = 25 Watts

The problem is exacerbated by current increasing, let’s double the current:

10 amps = 10²x 1 ohm = 100 Watts

Doubling current didn’t double the wattage loss, it quadrupled it!

With motor circuits, we are dealing with extremely low resistance values in the micro to milli-ohm range. Given that, it doesn’t take much to cause a significant resistance problem.

Given that almost all resistance problems are self-imposed, let’s look at some of the poor practices that create such problems. Achieving proper torque is essential.  How many of you use torque wrenches? Every fastener has a torque specification.  Why not use a torque wrench.  Less than 5% of industrial facilities utilize torque wrenches, including a number of the more regulated industries.  Improper crimps, multiple conductors in one lug, improper wires size vs. conductor, broken and cut conductor strands are some of the self-induced termination faults.  These can be alleviated by having set procedures for making up crimps and connections, with procedural adherence.  Local disconnects are notorious sources of high resistance. One of the most common problems is arcing and subsequent pitting from operation while under load.  Disconnects are for equipment isolation during maintenance, not an on or off switch.

With proper maintenance practices and procedures, connection anomalies can all but be eliminated. For more information on causes of resistance problems and electric motor testing. Contact the Snell Group and schedule one of our comprehensive training courses. Don’t forget to ask about our new De-Energized Electric Motor Data Analysis Wall Chart. A 36” x 48” laminated chart that is a wealth of information. Also, keep a lookout for our Energized Electric Motor Data Analysis Wall Chart. This should be making its debut early next year.